|
M10C
Vertical extrusion (a.k.a. "standard") that is used between two wall panels to create a wall panel system display area. Our standards have 1/2" slots, 1" on center; the space between two slots are an inch apart.
|
MS End Starter
Vertical starter extrusion that starts your wall panel system. This vertical extrusion is used when there is not a return wall on the other side.
|
|
MES End Starter
Vertical starter extrusion that is used when going around an outside corner of a wall panel system. This vertical extrusion will finish one side of the wall and will start the corner of other side of the wall.
|
MET End Trim
Vertical extrusion that is used to end / finish your wall panel system.
|